Inset panels which fit over sleepers . Designed to fit
Peco track but might fit other makes.
Just cut panels off along score lines between panels. They should fit over
sleepers easily, but might need trimming.
Suitable for straight, curved and flexi track.
Long 65cm strips can be cut to length, ideal for points
and crossovers.
Suggest using PVA glue to fit down.
If track is already ballasted, ballast will need removing before fitting
panels.
Intended to go between rails, but can also be fitted to outside of rail.
p9st-one-piece-n9-st-75-insert
p9st-one-piece-009-st75-insert
9st-left-point
9mm gauge left hand point with large stone surface. fit code 100 rail
9st-right-point
9mm gauge right hand point with large stone surface, fit code 100 rail
9mm gauge long straight section with large stone surface. Fits code 100 rail
9mm gauge long curved section, 9in radius, with large stone surface. fit code 100 rail
48 pieces of stone section top make flexi inset track 9mm gauge with large stones for narrow gauge(eg O9). fit code 100 rail.each section is 7mm long
24 pieces of small stone section top make flexi inset track 9mm gauge with plain no stones top. fit code 100 rail.each section is 7mm long.
