Inset panels which fit over sleepers . Designed to fit
Peco track but might fit other makes.
Just cut panels off along score lines between panels. They should fit over
sleepers easily, but might need trimming.
Suitable for straight, curved and flexi track.
65cm long single strip can be cut to length, Ideal for points and crossovers.
Suggest using PVA glue to fit down.
If track is already ballasted, ballast will need removing before fitting
panels.
Intended to go between rails, but can also be fitted to outside of rail.
indivual pieces and 65cm long strip (equivalent to approx 81 individual pieces)
p12-one-piece-12w75-insert-x24
large stone (O scale and larger)
indivual pieces and 65cm long strip (equivalent to approx 81 individual pieces)
p12st-one-piece-12st75-insert-x24
12stw-left-point-2r
12mm gauge, 435.75mm radius left hand point with small stone surface. fits code 100 rail
12stw-right-point-2r
12mm gauge, 435.75mm radius right hand point with small stone surface. fits code 100 rail
12mm gauge, 310mm radius, 30deg left hand point with small stone surface. fits code 100 rail
12mm gauge, 310mm radius, 30deg right hand point with small stone surface. fits code 100 rail
12mm gauge 22.5deg crossing with small stone surface. fit code 100 rail
12mm gauge, 310mm radius curve with small stone surface. Angle is 30deg. Fit code 100 rail.
12mm gauge curve(radius 435.75mm, angle 22.5deg) with small stone surface. fit code 100 rail
12mm gauge long straight with small stone surface. 168mm long. fit code 100 rail
